Filter
Top Products
[i!i! ::i:i ! ::i:i ! ::iSECTION 3 STEP BY STEP GUIDES TO INSTALL
D. CONNECT VALVE AND SALT TANK DRAINS
_1_ CONNECT THE VALVE DRAIN HOSE
Take a length of 3 / 8" inside diameter drain tub-
ing and attach one end to the drain fitting (FIG.
12). Use a tube clamp to hold it in place. Put the
other end of the tubing over a floor drain, into a
laundry tub, standpipe, or other suitable drain.
Check your local codes.
• Leave an air gap of about 1-1/2" between the end
of the hose and the drain. This gap is needed so you
don't get a back-flow of sewer water into the soften-
er. Do not put the end of the hose into the drain or
connect without the air gap.
• Place and support the hose so it does not kink or
have sharp bends. So water pressure does not cause
the hose to "whip", tie or wire it in place. Do not
pinch the hose shut. The softener will not work if
this drain hose is pinched, plugged, closed or re-
stricted in any way.
• Keep the hose lower than the drain fitting. (In
some homes, to get to a drain you must raise the
hose and run it over-head. If you need an overhead
drain, do not raise the hose more than 8' above the
floor. A copper drain tube is best to use.)
COPPER DRAIN TUBE: The plumbing codes
where you live may say that you must use a copper
valve drain tube. A copper tube is also best to use for
an over-head drain. Use a copper drain tube if the
softener is installed outside, or in the sunlight. Heat
from the sun makes many kinds of rubber or plastic
hose to soften, flatten and close up.
To adapt a copper drain tube to the softener, buy a
compression fitting (1/4 in. female pipe threads x
1/2 in. O.D. tube) and tubing from your local hard-
ware store.
DELUXE VALVE
grommet tube
adaptor
" _ tube
l_lamp
NOTE: Overflow
drain tubing is
available from
Sears, Item No.
42- 3433 (20 ft)
overflow drain --
tubing (see step 2,
top of page 3-6)
N\
x\
XX
\\
\\
NN
\\
X\
K\
N\
\x_... To drain point
"_ other than
valve drain hose floor drain.
(see step 1, above) Support tubing
in place as
needed.
1 1/_p,
tie or wire air gap
tubing in place 1
" 27
Optional copper drain hook-up,
check with local codes
_/_ _/L_ 11/4NPT Threads
barbs
"i ! Diameter
clip _ "::/ Copper Tube
#
(not furnished)
cut barbs
from drain fitting
(pull clip and remove
lilting from valve) .2"--...
Comp Fitting, 1/4 NPT
x 1/2 in. OD. Tube -...
(not furnished)
STANDPIPE
r gap
1-'_/' air gap
3-5
Deluxe Valve