Filter
Top Products
SECTION3 STEP BY STEP GUIDES TO INSTALL
F. GROUNDING / CONNECT TO ELECTRICAL POWER
_PLUG IN THE TRANSFORMER CONNECTING TRANSFORMER
Plug the transformer into the electrical outlet.
Transformer
120V-6OHz
Electrical
Outlet
Power Cable
from Face Plat_'13mer
Salt Hole
(Main)
INSTALL COVERS
After installing your water softener, replace the cov-
ers. For the UltraSoft 100, first position the main
cover on the softener. Then, set the salt hole cover
into the main cover, and lower closed. For the Ultra-
Soft 200, angle the covers so the main cover clips
onto the back first, then bring down in front and clip
on the 2 tabs inside the rim of the salt hole and lower
the salt cover closed.
RESTART THE WATER HEATER
TURN ON THE GAS (OR ELECTRIC) SUPPLY TO THE WATER HEATER AND LIGHT THE PILOT
Your new Sears softener is now softening the water
for your household needs. However, your WATER
HEATER is filled with hard water. To have fully
soft water right away, you can drain the water heat-
er so it refills with soft water. If you don't drain the
water heater, it will take a few days before you have
fully soft water.
To drain the water heater, open a hot water faucet
and let it run until the water runs cold. Then close
the faucet.
YOUR PLUMBING AND ELECTRICAL WORK IS COMPLETE.
Now go to your owner's manual and do the softener start-up steps...setting the timer, filling the
storage tank with salt, sanitizing, etc.
3-9
Deluxe Valve