Filter
Top Products
Service and Adjustment (cont'd)
Drain Valve Washer
Replacement
17. Fold the insulation back in place so that it completely covers
the thermostat and element.
NOTE: For replacement, use a _d' x _3Ad'x W' thick washer
available at your nearest hardware store. For ordering a
replacement washer, refer to the "Parts Order List" section.
18. Replace accesspanel.
19. "lhrn "ON" electric power to water heater.
• Before beginning turn "OFF" the electrical power supply to
the water heater.
AWARNING
HAZARD OF ELECTRICAL SHOCK! Before
removing any access panels or servicing the water
heater, make sure the electrical supply to the water
heater is turned "OFF". Failure to do this could
result in DEATH, SERIOUS BODILY INJURY, OR
PROPERTY DAMAGE.
• Follow "Draining" instructions in the "Service and
Adjustment" section.
• "Ihrning counter clockwise, remove the hex cap below the
screw handle.
• Remove the washer and put the new one in place.
%
A CAUTION J
Never use this water heater unless it is completely J
full of water. To prevent damage to the tank and J
heating element, the tank must be filled with water. J
Water must flow from the hot water faucet before
turn ng ' ON ' power.
• Screw the handle and cap assembly back into the drain valve
and retighten using a wrench. DO NOT OVER TIGHTEN.
• Follow "Filling the Water Heater" instructions in the
"Installation Instructions" section.
• Check for leaks.
• "Ihrn "ON" electric power to the water heater.
_ HANDLE AND
CAP ASSEMBLY
WASHER
Service
Before calling for repair service, read the "Start Up Conditions"
and "Operational Conditions" found in the Troubleshooting
Guide of this manual.
If a condition persists or you are uncertain about the operation
of the water heater, let a qualified person check it out.
Contact SEARS Repair Services at 1-800-4-MY-HOME
(1-800-469-4663)
17