Filter
Top Products
Installation Instructions (cont'd)
Filling the Water Heater Wiring Diagrams
"Ib fill the water heater with water:
• Close the water heater drain valve by turning the handle to
the right (clockwise). The drain valve is located on the lower
front of the water heater.
• Open the cold water supply valveto the water heater.
NOTE: The cold water supply valve must be left open
when the water heater is in use.
• _lb insure complete filling of the tank, allow air to exit by
opening the nearest hot water faucet. Allow water to run
until a constant flow is obtained. This will let air out of the
water heater and the piping.
A CAUTION J
Never use this water heater unlessit iscompletely full J
of water. To prevent damage to the tank and heating
element, the tank must be filled with water. Water I
must flow from the hot water faucet before turning
ON ' power.
• Check all new water piping for leaks. Repair as needed.
Optional Cord Set Wiring
(120Volt)
120 VOLT CORD SET
GREEN
There may be a cord set supplied with the water heater at the
time of manufacture. If not one can be ordered through the
Parts Department, see "Repair Parts" section. Refer to figureson
this page for wiring diagrams.
120 VOLT WIRING
THERMOSTAT
Lu GREEN
.JlGROONO
=
10