Filter
Top Products
ADVERTENCIA
Peligro de choque eléctrico o lesión cor-
poral
Apagué y desconecté la aspiradora
antes de efectuar el mantenimiento a su
aspiradora. De lo contrario podría pro-
ducirse un choque eléctrico o causar
lesión corporal si la aspiradora arranca
de manera imprevista.
Siempre deberán seguirse todas las precauciones de seguridad antes de efectuar el
mantenimiento a la PowerMate.
CUIDADO DE LA POWERMATE
PARA RETIRAR LA CORREA
1. Apagué y
desconecté la
aspiradora.
2.
Pise el pedal de
liberación rápida
del tubo y tire del
tubo hacia arriba
para desprenderlo
de la PowerMate.
3. Gire la
PowerMate para
mostrar la parte
inferior hacia
arriba y
desatornille cuatro
(4) tornillos de la
cubierta.
4. Gire la
PowerMate con la
parte superior
hacia arriba.
5.
Apriete el
pedal del
mango de
liberación y baje
la articulación
giratoria
9.
Observe la
posición de todo el
cableado y la
tarjeta del sensor
de polvo.
Quite el
agitador y la correa
gastada.
10. Examine y
limpie las áreas de tapa del extremo. En la
ENSAMBLE DEL AGITADOR (pág 24) se
proporciona una ilustración de todo el
ensamble del agitador.
Tornillos
Pedal de
liberación
rápida
del tubo
Pedal de
liberación
del mango
7. Agarre los
cierres laterales
y jale hacia a
fuera y levante.
8. Levante la
cubierta hacia
arriba y
quedara
liberada la
cubierta.
6. Jale hacia
fuera y levante
los cierres
posteriores.
Tapa del
extremo
Base
Pestillos
traseros
Pestillos
laterales
CAMBIO DE LA CORREA Y LIMPIEZA DEL AGITADOR
23
10
OPERATING INSTRUCTIONS
CAUTION
Moving parts! To reduce the risk of personal injury, DO
NOT touch the agitator when vacuum cleaner is on.
Contacting the agitator while it is rotating can cut,
bruise or cause other injuries. Always turn off and
unplug from electrical outlet before servicing.
Use caution when operating near children.
1. Pull cord out of
canister to desired
length. The cord
will not rewind
until the cord
rewind button is
pushed.
NOTE: To reduce the risk of electric shock,
this vacuum cleaner has a polarized plug;
one blade is wider than the other. This plug
will fit in a polarized outlet only one way. If
the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit,
contact a qualified electrician to install the
proper outlet. Do not change the plug in
any way.
Rewind
Button
HOWTOSTART
WARNING
Personal Injury and Product Damage
Hazard
• DO NOT plug in if switch is in ON
position. Personal injury or property
damage could result.
• The cord moves rapidly when
rewinding. Keep children away
and provide a clear path when
rewinding the cord to prevent
personal injury.
• DO NOT use outlets above counters.
Damage from cord to items in
surrounding area could occur.
• When any abnormality/failure occurs,
stop using the product immediately and
disconnect the power plug.
2. Plug the polarized power cord into a 120
Volt outlet located near the floor.
To rewind: Turn off
and unplug the
vacuum cleaner.
Hold the plug while
rewinding to
prevent damage or
injury from the
moving cord. Push
cord rewind button.
3. Lower wand from upright position by
pressing on the handle release pedal.
4. Select a height adjust setting by pressing
the HEIGHT ADJUST pedal on the rear of
the PowerMate. The height adjust setting
shows on the indicator. See SUGGESTED
HEIGHT ADJUST SETTINGS (page 13).
Attention: Refer to your carpet
manufacturers cleaning recommendations.
Some more delicate carpets may require
that they be vacuumed with the PowerMate
agitator turned off to prevent carpet
damage.
Height Adjust
Indicator
Handle
Release
Pedal
HEIGHT
ADJUST
Pedal
ESPAÑOL