Filter
Top Products
TO REMOVE BELT
1. Remove light cover
and light butb as shown
under LIGHT BULB
CHANGING
2, Unscrew the Power-
Mate ®cove r screws,
3, Turn
Power-Mate s
ove r,To
remove cover,
insert
screwdriver at
cover tabs on
both sides
and twist to
release tabs,
5. Carefully
insert and
lift
screwdriver
at each
brush
support to
free brush
from base
6, Remove
worn belt,
Brush
Support
Tab
4. Turn Power-
Mate s right side
up, Press handle
release pedal
and lower the
swivel Rotate
cover forward
from back until
front snaps free,
7. Slide brush
supports off to
check and clean
brush support
areas See
BRUSH
ASSEMBLY for
picture of
complete brush
assembly,
TO REPLACE BELT
1. Slide washers and brush supports onto
brush assembly.
2. Install
new belt
over motor
drive, then
over brush
sprocket.
NOTE: See 1
PARTS AND Brush
FEATURES Support
for Belt number,
Motor
Drive
Brush
Brush Sprocket
3o Snap brush
supports into
place on base,
Be sure brush
supports are
not upside-
down
4. Line up
front of cover
and base.
Rest cover
on front edge
of base as
shown°
Cover
Base
5. Rotate cover
back° Press
cover firmly until
side tabs snap
into place.
Replace cover
screws, light
bulb and light
cover
16