Filter
Top Products
HALF LIGHT POWER-MATE ®
1. Remove light
cover by lifting at
arrow as shown.
2. Push in and turn
bulb countercfock-
wise to remove,
3. Replace the
bulb, Bulb must not
be higher than 15
Watts(130V),
Close _ight cover
until it snaps in
place
1/4
NOTE: See PARTS AND FEATURES for
Bulb number_
FULL LIGHT POWER-MATE d
1, Remove light
cover by pressing
in and lifting both
sides as shown.
2, Push in and turn
bulb counterclock-
wise to remove.
3. Replace the
bulb Bulb must not
be higher than 15
Watts (130V).
Close light cover
until it snaps in
place,
PushIn
And Turn
NOTE: See PARTS AND FEATURES for
Bulb number.
CAUTaON
When you remove the end caps, a
small metal washer on each end
may come off, DO NOT lose these
two metal washers.
TO CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacuum,
the agitator must be cleaned every time the
belt is changed_,
The agitator must also be cleaned according
to the following schedule:
Vacuu_ Use
HEAVY -
(used daily)
MODERATE -
(used 2-3 times/week)
LIGHT -
(used 1 time!week)
Clean Agitator
every week
every month
every 2 months
Remove any dirt or debris in the belt path
area or in the brush roller area.
any string or
debris located on
the agitator, end
caps, washers or
agitator shaft.
IMPORTANT
Replace the washers and the end caps.
See the exploded view for correct
assembly,
Disconnect cleaner from electrical outlet.
Check and remove hair, string and lint build-
®
up frequently in the Power-Mate agitator'
and end cap area& If build-up becomes
excessive, disconnect Power-Mate ® from
wand and follow the steps below,
15