Filter
Top Products
12
7. Lift out the Burner Plate: NOTE: There are no screws
securing the Burner to the floor of the firebox. Pull the
Air Shutter forward and lift the burner together with
shutter up and out of the stove as a unit. See fig. 13.
8. Change the Burner Orifice. Using a ½” open ended
wrench or deep-well socket, remove the burner
orifice from its brass elbow housing and replace with
the appropriate orifice supplied in the kit. See fig. 14.
9. Replace the Air Shutter and push it all the way back
to allow replacement of the Burner Plate. Reattach
the wingnut and gasket to the shutter stem under
the stove, but do not tighten. You will set its final
position later.
10. Replace the Burner Plate. Engage the burner tube
with the Air Shutter assembly as in fig. 14. Be sure
the burner is securely engaged with the two support
brackets at the front of the firebox and push the
plate back toward the rear of the firebox.
11 . CHANGE THE PILOT ORIFICE: From within the
firebox, remove the Pilot Head by pulling it straight
up from the pilot base. See fig. 16. Using the 4 mm
hex key included with the kit, unscrew the pilot orifice
(counterclockwise). Replace with the appropriate
orifice:
12. Tighten orifice into the base of the pilot assembly. To
prevent bypass leaks, be sure the orifice is secured
tightly and flush with the base. Replace pilot head by
pushing it down onto the pilot base.
13. Replace the Variable Regulator. Using a Torx T-20
screwdriver, remove the three screws from the front
of the valve regulator. See fig. 17.
14. Remove the regulator tower, gasket, white plastic
disk, and spring. See fig. 17.
Figure 13. Remove the Air Shutter and Burner as a unit.