Filter
Top Products
58
SAVE THESE INSTRUCTIONS
Page 12
(58) MODEL 604 FILTER PUMP ENGLISH 7.5” X 10.5” PANTONE 295U 01/19/2007
COMMON POOL PROBLEMS
CCOOMMMMOONN PPRROOBBLLEEMMSS
PROBLEM DESCRIPTION CAUSE REMEDY
ALGAE
COLORED
WATER
SUSPENDED
MATTER IN
WATER
CHRONIC
LOW WATER
LEVEL
SEDIMENT
ON POOL
BOTTOM
SURFACE
DEBRIS
• Chlorine and pH levels
need adjustment.
• Copper, iron or
maganese in water
being oxidized by the
added chlorine.
Common.
• "Hard water" caused
by pH level being too
high.
• Chlorine content is low.
• Foreign matter in
water.
• Rip or hole in pool
liner or hoses. Tighten
caps.
• Heavy use, getting in
and out of pool.
• Pool too close to
trees.
• Super chlorinate with shock
treatment. Correct pH to your
pool store's recommended
level.
• Vacuum pool bottom.
• Maintain proper chlorine
level.
• Adjust pH to recommended
level.
• Run filter until water is clear.
• Clean cartridge frequently.
• Correct pH. Check with pool
dealer for water treatment.
• Check for proper chlorine
level.
• Clean or replace your filter.
• Repair with patch kit.
• Finger tighten all caps.
• Use Intex pool vacuum to
clean bottom of pool.
• Use Intex pool skimmer.
• Greenish water.
• Green or black
spots on pool liner.
• Pool liner is
slippery and/or has
a bad odor.
• Water turns blue,
brown, or black
when first treated
with chlorine.
• Water is cloudy or
milky.
• Level is lower than
on previous day.
• Dirt or sand on
pool floor.
• Leaves, insects
etc.
IMPORTANT
If you continue to experience difficulty, please contact our
Consumer Service Department for assistance. See back cover for
contact information.