Filter
Top Products
7
68” METAL AND GLASS TV STAND
www.insigniaproducts.com
Step 3: Attaching the side bases to the back base
1 From the inside of the back base (C), insert short screws (M) through the screw holes on the tabs and into the
screw holes on the left base (D). On the back base (C), make sure that the suction cups (O) face up and the screw
holes face out. Use the Allen wrench (Q) to tighten the screws.
2 Repeat this step to attach the right base (E) to the back base (C).
Make sure that
these holes face up.
You’ll need:
M (4)
Q (1)
NS-MG1205-C_14-0264_MAN_V1_ENG.fm Page 7 Wednesday, April 30, 2014 3:29 PM