Filter
Top Products
61
7
REFERENCES
7
7-4 Failure in searching for the AP-12
Manual IP address setting is necessary when no AP-12 is found (the following
screen appears) using [Easy Setting Wizard] or [AP-12 Manager], even if the con-
nection between the AP-12 and the PC is correct.
• The following screen may take 30 sec. or more to appear.
DD
When using [Easy Setting Wizard]
DD
When using [AP-12 Manager]
[Procedure]
q Connect the PC and the AP-12 directly using the supplied crossover cable.
NOTE: DISCONNECT THE PC FROM THE EXISTING LAN.
When the PC is connected to the existing LAN, the AP-12 searches the DHCP
server and uses the IP address obtained from the server according to the
default setting.
w Start [AP-12 Manager] (p. 27).
e Click <Set IP>.
• <Access point IP address setup tool> screen appears.
Access point does not appear.
Click
AP-12_USA 02.7.26 9:33 AM Page 61 (1,1)