Filter
Top Products
41225-01 10/95 - 7 - ©1995 HUNTER FAN CO.™
TROUBLESHOOTING GUIDE
PROBLEM PROBABLE CAUSE SOLUTION
*NOTE: If blades will not turn by hand, contact your nearest service representative.
When switching from medium to low speed, you may notice some fan wobble. When fan speed stabilizes at low speed, wobble will
disappear. If you have checked the above problems and still have trouble, call (901) 745-9222.
1. Nothing happens;
fan does not move.*
2. Noisy operation.
3. Excessive wobbling.
1. Power turned off or fuse blown.
2. Loose wire connections or wrong connections.
3. Pull chain switch not ÒON.Ó
1. Blade brackets loosely screwed to motor.
2. Blade screwed loosely to blade bracket.
3. Blade cracked.
4. Non-Approved speed control being used.
1. Blade brackets not attached at proper locations.
2. Unbalanced blades.
3. Fan too close to vaulted ceiling.
4. Loose blades or blade brackets.
5. Fan not secure on hanger assembly.
1. Turn power on or replace fuse.
2. Loosen canopy. Check all connections.
(Turn power off while checking.)
3. Pull switch chain.
1. Tighten screws until snug.
2. Tighten screws.
3. Replace all blades
4. Change to approved speed control.
1. Carefully review Step 8.
2. Use blade balancing kit. (See Step 8C.)
3. Lower or move fan.
4. Tighten all screws.
5. Turn power off. Support fan very carefully.
Loosen canopy and hang correctly.