Hunter Fan 45007 Fan User Manual


  Open as PDF
of 15
 
8
45007-01•11/02/07•HunterFanCompany
All wiring must be in accordance with national and local
electrical codes and ANSI/NFPA 70. If you are unfamiliar with
wiring, use a qualified electrician.
5-1. Make sure the power is still off.
5-2. Positionthereceiverinthecanopysothattheantennaisclose
to the edge of the ceiling plate for clear reception.
5-3. To connect the wires, hold the bare metal leads together
and place a wire connector over them, then twist clockwise
until tight. For all these connections use the wire connectors
provided.
CAUTION: Be sure no bare wire or wire strands are visible after
making connections.
5-4. Usingalargewireconnector,connectthegroundwirefromthe
ceiling to the green ground wire from the ceiling plate and the
green ground wire from the downrod.
5-5. Usingthelargewireconnectors,connectthewhitewireandthe
black wire from the ceiling as follows:
•
e white (common) power wire from the ceiling to the white
wirefromthereceiver(markedonredtag“NEUTRALIN”)
•eblackpowerwirefromtheceilingtotheblackwirefrom
the receiver (marked on red tag “LIVE IN”)
5-6.Usingthesmallwireconnectors,connectthewiresfromthefan
as follows:
•eblack/whitewirefromthefantotheredwirefromthe
receiver(markedonwhitetag“LIGHTOUT”)
•eblackwirefromthefantotheblackwirefromthe
receiver(markedonwhitetag“FANOUT”)
•ewhitewirefromthefantothewhitewirefromthe
receiver(markedonwhitetag“COMMONOUT”)
5-7. Check each connection to make sure no bare wire or wire
strands are visible. Push all wires and wire connectors, except
for the white antenna wire from the receiver, back through the
ceiling plate into the outlet box.
5 • Wiring the Fan
Step 5-4
Step 5-5
Step 5-6
Receiver
Antenna
 previous next