Hunter Fan 45007 Fan User Manual


  Open as PDF
of 15
 
6
45007-01•11/02/07•HunterFanCompany
3-1. To assemble fan to hang down from a flat or angled ceiling, place
the canopy and canopy trim ring around the adapter so that they
rest on the fan assembly.
3-2. Feedthewiresfromthefanthroughthedownrod.
Note: Make sure all the wires are on the same side of the metal
dowel pin inside the dowrod.
3-3. Loosen the square head set screw on the adapter to install the
pipe and ball assembly. Note: When the pipe and ball assembly
isfullyinstalled,2-3threadsonthepipewillstillbevisible;thisis
normal. Securely retighten the set screw with a wrench or pliers.
CAUTION: e adapter has a special coating on the threads. Do
not remove this coating; the coating prevents the downrod from
unscrewing.Onceassembled,donotremovethedownrod.
WARNING: Do not carry or lift fan by canopy.
3-4.Raisethefanandplacetheballintothehangerbracket.
3-5. Alignthenotchontheballwiththeindentinthehangerbracket.
(Rotatethefanuntilyouhearthenotchpopintoplace.)
Goto4 • Wiring the Fan.
WARNING: Fan may fall if not assembled as directed in these
installation instructions.
Steps 3-4 – 3-5
Indent
Steps 3-1 – 3-3
Downrod
Canopy
(with Washer)
Canopy
Trim
Ring
Set Screw
Adapter
3 • Assembling and Hanging the Fan
 previous next