Hunter Fan 45007 Fan User Manual


  Open as PDF
of 15
 
5
45007-01•11/02/07•HunterFanCompany
2-1. Drilltwopilotholesintothewoodsupportstructurethroughthe
outermost holes in the outlet box. e pilot holes should be 9/64”
in diameter.
Note: Your fan comes with four pre-installed neoprene noise
isolators.
2-2. readtheleadwiresfromtheoutletboxdownthroughthehole
in the middle of the hanger bracket.
2-3. Aligntheslottedholesinthehangerbracketwiththepilotholes
you drilled in the wood support structure. For proper alignment
use slotted holes directly across from each other. If you are
installing the fan on an ANGLED ceiling, be sure to orient the
hangerbracketasshowninIllustration2-3(leftorrightview).
Note: e isolators should be flush against the ceiling.
2-4. Placeaatwasheroneachofthetwo3”screwsandpassthe
screws through the slotted holes in the hanger bracket into the
pilot holes you drilled.
Tighten the screws into the 9/64” pilot holes; do not use lubricants
on the screws. Do not over tighten.
Flat Washer
3” Screw
Steps 2-2 – 2-4
Hanger
Bracket
Isolator
Step 2-3 (Angled Ceiling Only)
OR
Ceiling Peak Ceiling Peak
Large
Opening
Large
Opening
LEFT RIGHT
2 • Installing the Hanger Bracket
 previous next