Hunter Fan 42775-01 Manual

next previous

42775-01•04/29/08•HunterFanCompany

3 • Assembling and Hanging the Fan

U-shaped

Hole

Step 3-7

Steps 3-5 – 3-6

Low Proﬁle Washer

For Low Proﬁle mounting:

Note: For low proﬁle mounting, the downrod is replaced with

the low proﬁle washer.

3-5. Removethesetscrewfromtheadapter.

3-6. Place the low proﬁle washer (lip up) into the canopy. Be

sure the green ground wire is pointing up toward the

ceiling.

3-7.Aligntheholesinthewasherwiththeholesintheadapter.

Assemblesecurelywiththreelowprolescrews.

3-8.Raisethefanandplacethehookontheceilingplatethrough

theU-shapedholeintherim.

Optional Downrod Instructions:

YourHunterfancomeswithanoptionaldownrodextension

pipe. If you would like to use the enclosed optional 6 inch

downrod, follow the steps below.

Note: e Perfect Balance

system is designed for downrods

that are 6” and shorter. If you use a downrod longer than 6

inches, do not remove the red retaining screws.

3-9. Removethepipeballscrewfromthestandarddownrod,

then slide the ball oﬀ the pipe.

3-10.Removethepinfromthepipe,thenslidethewedgeothe

pipe.

3-11.Removethescrewandgroundwirefromthepipe.

3-12.Reassemblethegroundwire,wedge,pin,ball,andpipeball

screw, in that order, onto the long downrod.

3-13. Go back to Step 3-2.

Steps 3-9 – 3-12

GroundWire

and Screw

Pipe Ball Screw

Wedge

Ball

Low Proﬁle Screw