Filter
Top Products
– 30 –
Accessing Other Panels (cont’d)
Press 0 to exit mode. After a few seconds, the keypad displays the status
of the original partition of the original panel for the keypad. Also, this mode
will end in approximately 120 seconds if no keys are pressed.
NOTES:
When performing any of the arming commands, if there are faults in any of
the partitions of a panel, the system will not arm that panel, but will arm all
the other partitions of the other panels.
When performing either a STAY or INSTANT arm command the system
always arm in mode 1 (see page 36 Arming Perimeter Only for a detailed
explanation of the STAY arming modes.
The user cannot execute another panel linking mode. To execute another
panel linking mode or to access a different remote panel, the user must first
exit this mode (return to the original control panel).
Priority of Displays for Multi-Partition and Multi-Panel Modes
This table shows the priority of displays if more than one of the conditions
exists at the same time.
Priority Description Display
1 Fire Alarm
F
2 All Other Alarms
✴
3 AC Loss
P
4 Comm Fail
C
5 System Low Battery
L
6 Trouble
T
7 Bypass
B
8 Not Ready
N
9 Ready
R
10 Armed STAY
S
11 Armed AWAY
A
12 Armed INSTANT
I
13 Armed MAXIMUM
M