Filter
Top Products
THX9321 PRESTIGE
®
2.0 AND THX9421 PRESTIGE
®
IAQ 2.0 WITH EIM
68-0311—01 12
ERROR MESSAGES:
E1 29: Incompatible device cannot be connected.
E1 34: Low RF signal. Move device to a different location and
try again.
E1 38: Make sure the thermostat, EIM, or TrueZONE Wireless
Adapter is in Wireless Setup mode, and the Portable Comfort
Control is at least 2 feet away (600 mm).
NOTE: The linking procedure will time out if there is no
keypress for 30 minutes. To begin again, press
and hold in the lower right corner of the screen
until the display changes (about 3 seconds). See
Fig. 26.
Fig. 26. Restarting the linking process.
Link RedLINK Internet Gateway
1. Press and release the button on the bottom of the Inter-
net Gateway. After a short delay, the RedLINK status
light will glow steady green.
Fig. 27. RedLINK Internet Gateway connect button.
NOTE: The Internet Gateway must be registered online
before use at www.mytotalconnectcomfort.com.
Enter the MAC ID and MAC CRC numbers located
on the bottom of the Internet Gateway. For addi-
tional information, see instructions provided with
the device.
Link TrueSTEAM
1. Press and release the CONNECT button on THM4000
Wireless Adapter. After a short delay, the CONNECTED
status light will glow steady green.
Link Wireless Indoor Sensor
1. Press and release the CONNECT button. After a short
delay, the status light (see Fig. 25) will glow green for 15
seconds. If the status light turns red, the sensor did not
link with the thermostat.
Fig. 28. Wireless indoor sensor connect button and status
light.
NOTE: In normal operation, the status light remains off.
If it begins flashing red, batteries are low (power
will be depleted after 2–3 weeks).
2. If you are installing more than 1 wireless indoor sensor,
give each sensor a name as you install it. Press Name
Device, as shown in Fig. 29.
Fig. 29.
3. Type the sensor name and press Done. The sensor
names are used when selecting which sensor to use for
temperature, humidification, and dehumidification con-
trol.
Fig. 30.
Press and hold
the blank space
(or arrow may be
present)
MCR32943
MCR32934
MCR32935