Filter
Top Products
– 69 –
Quick Guide to System Functions
FUNCTION PROCEDURE COMMENTS
Check Zones Press [✱]. To view faulted zones when is system not ready
Display All
Descriptors
Press and hold [✱] for 5 seconds. Displays all alpha descriptors programmed by
installer.
Arm System Enter code.
Press arming key desired (AWAY,
STAY, INSTANT, MAXIMUM).
Arms system in mode selected.
NOTE: After pressing the STAY or INSTANT
arming key, enter 1, 2 or 3 to arm in
the desired STAY or INSTANT mode.
Disarm System Enter code. Press OFF [1]. Disarms system and silences alarms.
Bypass Zones Enter code. Press BYPASS [6].
Enter zone numbers to be
bypassed (use 3-digit entries).
Bypassed zones are unprotected and will not
cause an alarm if violated.
Quick Bypass Enter code. Press BYPASS [6].
Press [#].
Bypasses all faulted zones automatically.
Group Bypass Enter code. Press BYPASS [6].
Press [✱]. Enter Group Number
(01-15)
Bypasses all zones assigned to the group.
Chime Mode Enter code. Press CHIME [9]. Keypad will sound if doors or windows are
violated while system disarmed.
Test Mode Enter code. Press TEST [5] Activates alarm sounder and allows sensors to
be tested.
View Messages Press and hold [0] for at least 5
seconds.
Message from central station will appear.
View User
Capabilities
Enter user's code. Press [✱] + [✱]. Displays partitions & authority levels assigned
to the user.
GOTO Partition Enter security code. Press [✱].
Enter partition number (1-8).
0 returns to default partition.
Allows a user at one keypad to perform
functions in another partition, if that user is
authorized to do so.
Self-Help Press and hold any function key for
at least 5 seconds.
Will display abbreviated instructions for the key
pressed.
Add a User Enter master/manager code.
Press CODE [8].
Enter new user's user number.
Enter code for that user.
Enter authority for that user in this
partition (1-5).
Follow prompts, 1=Yes, 0=No.
Master & Manager level users can add users to
the system, each with its own code and
authority level.
Change a User's
Code
Enter master/manager code.
Press CODE [8].
Enter user's 3-digit number.
Enter new code for that user.
Press 0 (No) at prompt.
Master & Manager level users can change their
own or other users' codes.