Filter
Top Products
– 57 –
Event Log Procedures
General Information
The system has the ability to record various events in a history log wherein each event is
recorded in one of five categories (listed below), with the time and date of its occurrence. The
Event Log holds up to 1000 events, with the oldest event being replaced by the logging of any
new event after the log is full. Using an alpha keypad, the Event Log can be viewed one
category at a time, or can display all events, regardless of category (ALL EVENT LOG). The
system also allows selection of displaying the COMPLETE log, or only those events occurring
since the last installer service (RECENT). In addition, events in the other partitions can be
viewed by users authorized to access those partitions. Note that events are displayed in
chronological order, from most recent to oldest.
To Display the Event Log
1. Enter CODE + #
+ [6] + [0]
2. Select the display mode.
RECENT: Displays only those events occurring since last Event Log Clear command was
executed.
COMPLETE: Displays complete event log (up to 1000 events).
Press the desired key, 0 or 1.
ENTER 0 = RECENT
1 = COMPLETE
3. Select the partition, 0-8.
Enter the partition number for the partition whose events are to be displayed.
Entering 0 (NO) will display all partitions' events.
SCAN LOG BY PART
0 = NO 1-8 = PART#
4. Use the [3] & [1] keys (for next and previous categories respectively) to display the
categories of events.
Press [8] to select a category and display the first event. Press [8] again for each
subsequent event.
Shows burglary alarm occurred in zone 3 (C003) of partition 1 (P1), at 12:02AM on
January 1.
P1 01/01 12:02AM
BURGLARY C003
Typical
Event Log
Display