Filter
Top Products
Heatilator • I80 CAN-US • 4013-203 Rev F • 04/08
16
• Remove fi replace from pallet. The fi replace is attached
to pallet with two brackets on each side and rear of outer
shell. See Figure 4.11. Remove screws from bracket, pallet
and fi replace. Replace screws removed from fi replace.
Slide fi replace into position (brackets can be used to
anchor fi replace in position). Once fi replace has been put
into position, install refractories.
Figure 4.11 Removing Shipping Brackets
• Install back refractory, making sure refractory is
centered and notches are to the bottom of fi rebox. Place
grate brackets in outer two notches of refractory. See
Figure 4.13.
• Secure back refractory in place with a screw and bracket
supplied in hardware package. See Figure 4.14.
Note: Before installing refractories and hearth stone, be
sure all back edges of each piece are smooth to ensure
proper fi t. Scrape away excess with a regular screwdriver.
See Figure 14.12.
Figure 4.12 Scrape Away Rough Edges
REFRACTORY
BRACKET
Figure 4.14 Attaching Back Refractory
GRATE BRACKETS
Figure 4.13 Back Refractory with Grate Brackets in Place