Heatiator I80 Indoor Fireplace User Manual


 
Heatilator • I80 CAN-US • 4013-203 Rev F • 04/08
14
Handle up - open
Handle down - closed
Figure 4.4 Locating the Outside Air Control
Outlet placed
higher than 3 ft
below the
termination cap
Attic space
Garage or
combustible
liquids storage
Outlet blocked by
snow, leaves, etc.
Clear area
outside
house or in
ventilated
crawl space
YES
NO
NO
NO
NO
Use only duct materials specified
by manufacturer (preferably with
short run or mainly straight duct,
except small dip for cold air trap
which will help prevent flow of cold air).
Factory-built
fireplace
Figure 4.3 Outside Combustion Air Placement
3 ft min. from top of
uppermost chimney
section to air inlet.
Attic insulation shield
must be used to keep
insulation away from
chimney.
Ceiling firestop
on floor of attic.
11-10 in./279-254mm
adaptor not shown
Figure 4.2 Typical Outside Air Inlet Locations
Note: Chimney air kit and 11-10 in./279-254mm
adaptor are required in Canada.