Filter
Top Products
Heatilator • GB4336/GB4992 • 4003-085 Rev H • 04/06 23
E. Junction Box Installation
• Remove the junction box assembly from the valve
compartment.
• If the box is being wired from the OUTSIDE of the
appliance;
- Loosen two screws on the Romex connector, feed the
necessary length of wire through the connector and
tighten the screws.
- Make all necessary wire connections to the receptacle
and assemble the receptacle and cover to the junction
box.
- Attach the junction box assembly to the outside of the
appliance with the two screws provided.
• If the box is being wired from the INSIDE of the
appliance;
- Pull the electrical wires from outside the appliance
through this opening into the valve compartment.
- Loosen the two screws on the Romex connector, feed
the necessary length of wire through the connector and
tighten the screws.
- Make all necessary wire connections to the receptacle
and assemble the receptacle and cover to the junction
box.
- Attach the junction box assembly to the inside of the
appliance with the two screws provided.
• If the box is not to be wired at the time of appliance
installation, assemble the receptacle and cover to the box
and install on the inside of the appliance.