Filter
Top Products
Heat & Glo • SLR • 2143-900 Rev. B • 7/08 52
0 in.
0 in.
0 in.
NON-COMBUSTIBLE
BOARD
Top Joint
Side
Joint
Bottom
Joint
Non-Combustible
Finishing Material
4 in. MINIMUM
Non-Combustible
Finishing Material
4 in. MINIMUM
Non-Combustible Finish Material 0-4 Inches Thick
Bottom
Joint
3/4 IN.
3/4 IN.
Figure 13.16 Noncombustible Surface Finishing Material 0-4 Inch
Thick-Inside Fit Method (Tonic Decorative Front Only)
Figure 13.15 Noncombustible Surface Finishing Material 0-4
Inches Thick-Inside Fit Method (Tonic Decorative
Front Only)
The Tonic decorative front is approved for inside fi t ap-
plications. Non-combustible fi nishing materials up to 4
inches thick can be installed around the Tonic front (left,
right, top, and bottom). The inside fi t method requires an
additional 4 in. of 1/2 in. thick non-combustible building
material (not supplied with fi replace) to be installed on
the left and right sides fl ush with the factory installed non-
combustible board. See Figure 13.15.
WARNING! Risk of Fire! The Martini decorative Front
is not approved for inside fi t installations. DO NOT install
Martini decorative front using an inside fi t application.
Resulting elevated \temperatures may cause overheating
and fi re.
For the Tonic decorative front inside fi t applications, the
decorative front must be installed tightly to the fi nishing
fl anges and must not overlap any fi nish material.
Ensure that no non-combustible fi nish materials are in-
stalled within 3/4 in. of the fi replace opening. The 3/4 in.
spacing is required to provide clearance for removing and
installing the Tonic decorative front. See Figure 13.16.
Note: The Inside Fit application is only approved for the
Tonic decorative front.
FACTORY-INSTALLED
NON-COMBUSTIBLE
BOARD
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
\\\
DRYWALL OR
EQUIVALENT
(1/2 IN.)
0-4 IN.
17-1/2 IN. APPLIANCE
OPENING (HEIGHT)
0- 4 IN.
Figure 13.14 Inside Fit Method (Tonic Decorative Front Only)
Non-Combustible Finish Materials
0 Inches to 4 Inches Thick Inside Fit Method