Filter
Top Products
Heat & Glo • Crescent II • 2083-902 Rev. N • 7/09 19
7
7
Appliance Preparation
CAUTION
Sharp Edges
• Wear protective gloves and safety
glasses during installation.
A. Securing and Leveling the Appliance
Figure 7.1 Proper positioning, leveling and securing of an
appliance
Fire Risk.
• ALWAYS maintain specifi ed
clearances around the appliance.
• Do NOT notch into the framing around the appliance spacers.
Failure to keep insulation, framing or other material away from
the appliance may cause fi re.
Fire Risk.
• Prevent contact with sagging, loose insulation.
• Do NOT install against combustible materials
such as exposed insulation, plastic and insulation
backer.
WARNING
WARNING
• Place the appliance into position.
• Level the appliance from side to side and front to back.
• Shim the appliance, as necessary. It is acceptable to use
wood shims.
• Remove two side screws from each nailing tab (see
Figure 7.2) and refasten nailing tabs to the appliance.
Note: Return bend on nailing tab faces back of unit.
• Keep nailing tabs fl ush with the framing.
• Secure the appliance to the framing by using nails or
screws through the nailing tabs.
• Holes are also provided in appliance bottom to secure
appliance to fl oor.
NAILING TABS
BOTH SIDES
2 HOLES IN BASE FOR
MOUNTING TO FLOOR
The diagram shows how to properly position, level, and
secure the appliance (see Figure 7.1). Nailing tabs are pro-
vided to secure the appliance to the framing members.
REFASTEN
NAILING
TAB
SCREWS (2)
NAILING
TAB
REMOVE
SCREWS (2)
FRONT
VIEW
BACK
VIEW
TOP
VIEW
DETAIL A
RETURN BEND FACES
THE BACK OF THE UNIT
Figure 7.2 Nailing tabs