Filter
Top Products
30
Installing the Trim
Combustible materials may be brought up to the specified
clearances on the side and top front edges of the fireplace,
but MUST NEVER overlap onto the front face. The joints
between the finished wall and the fireplace top and sides
can only be sealed with a 300° F. (149° C) minimum sealant.
WARNING: WHEN FINISHING THE FIREPLACE,
NEVER OBSTRUCT OR MODIFY THE AIR IN-
LET/OUTLET GRILLES IN ANY MANNER.
Install optional marble and brass trim surround kits as
desired. Marble, brass, brick, tile, or other non-combustible
materials can be used to cover up the gap between the
sheet rock and the fireplace.
Do not obstruct or modify the air inlet/outlet grilles. When
overlapping on both sides, leave enough space so that the
bottom grille can be raised and the trim door removed.
Positioning the Logs
The gas logs have been factory installed and they should
not need to be positioned.
If sooting occurs, the logs might need to be repositioned
slightly to avoid excessive flame impingement.
!
Step 10. Installing Trim, Logs,
and Ember Material
Placing the Ember Material
Ember material is shipped with this gas fireplace. The bag
labeled Golden Embers (GE-93) is flame colorant material.
The bag labeled Glowing Ember (050-721) is standard
glowing ember material.
To place the ember material:
Remove the wing nuts, glass clips and spring clips
around the glass door.
Remove the glass door from the unit.
Ember material is to be placed on the burner with cau-
tion. NOTE: Do NOT place ember material over burner
port holes. Place only dime size pieces along outer
edges of port trails. This bag is sized for (4) ember ap-
plications. Follow Figure 34 for correct placement. Fail-
ure to apply ember material as directed could result in
poor lighting conditions and sooting problems. After plac-
ing ember material sprinkle GE-93 on top of the burner.
Save the remaining ember materials for use during fire-
place servicing.
Replace the wing nut, glass clips and spring clips.
Optional mesh (see Figure 35).
Figure 35.
Figure 34. Placement of Ember Material
PILOT
ASSEMBLY
INCORRECT
EMBER PLACEMENT
FIRST
GRATE BAR
EMBER
MATERIAL
DO NOT PLACE EMBER
MATERIAL ON FIRST
SECTION OF PORTS
FROM THE PILOT TO
THE FIRST GRATE BAR.
CORRECT
EMBER
PLACEMENT
MESH
CLIP
If using the optional mesh doors, attach to fireplace glass
doors using the mesh clips provided in your manual bag,
as shown.
CAUTION: IT IS STRONGLY RECOMMENDED THAT
TRIM DOORS WITH OPTIONAL MESH SCREENS BE
INSTALLED ON PROPANE MODELS.
Replace the glass door and a front trim door on the unit
(see Parts List Section of this manual.)
Hand tighten the wing nuts.