Filter
Top Products
Heat & Glo • Bravo • 704-902 Rev. E • 7/08 37
Log Assembly: LOGS-BRAVO
E. Positioning the Logs
If the gas logs have been factory installed they should not
need to be positioned. If the logs have been packaged
separately, refer to the following instructions.
704-936C
CAUTION: Logs are fragile!
Carefully remove the logs
from the packaging.
Before placing logs, check
that the sensor on the pilot
assembly does not contact
the burner.
Remove shipping bracket
and tie straps from the burn-
er and grate.
Place the lava rock on the
bottom of the fi rebox. Evenly
spread the lava rocks with
your hand.
LOG #1 (SRV750-703): Place log #1 between log tabs on left side and right side of the burner. Place such that
bottom surface of log rests on burner surface (left).
1
2
4
5
3
6
GROOVE FOR
LOG #2
1
1
LEFT LOG
TAB
RIGHT LOG
TAB
BURNER
TAB
GRATE
Shipping Bracket
TIE STRAPS
SENSOR
ADJUST LOG SO
SURFACE IS FLUSH