Filter
Top Products
Heat & Glo • Bravo • 704-902 Rev. E • 7/08 31
WHT
WHT
BLK
BLK
GRN wire
inside box
Copper
ground attached
to GRN screw with
GRN wire
14/2WG
Cover Plate
outside firebox
Romex
Connector
If the box is being wired from the OUTSIDE of
the appliance:
• Remove the cover plate located on the outer
shell - right side (see Figure 10.3).
• Install the supplied Romex
™ connector in the
cover plate.
• Feed the necessary length of wire through the
connector.
• Make all necessary wire connections and reat-
tach the cover plate to the outer shell.
If the box is being wired from the INSIDE of the
Figure 10.3 Junction Box Detail
• Feed the necessary length of wire through the connector.
• Make all necessary wire connections to the junction box/re-
ceptacle and assemble the junction box/receptacle to the outer
shell.
appliance:
• Remove the screw attaching the junction
box/receptacle to the outer shell, rotate the
junction box inward to disengage it from the
outer shell (see Figure 10.3).
• Pull the electrical wires from outside the ap-
pliance through this opening into the valve
compartment.
Note: Do NOT wire
110VAC to wall switch.
E. Junction Box Installation