Filter
Top Products
9
Heat Controller, Inc. VMH SerieS Installation Manual
4
Accessories for mini-split high wall mount installation
INSTALLATION INSTRUCTIONS
Note: Except for the above parts provided, any other parts needed during installation you must
purchase.
Level gauge
Screwdriver
Electric drill,Hole core drill (65Ø1/4” mm)
Flaring tool set
Torque wrench: 1.8kgf.m, 4.2kgf.m,
Spanner (half union)
Hexagonal wrench 1-1/2”(4mm)
Gas-leak detector
Tools needed for installation:
Vacuum pump
Gauge manifold
Users manual
Thermometer
Multimeter
Pipe cutter
Measuring tape
6
2
Self-tapping Screw B ST2.9X10
Remote controller
Installation Plate
Name of Accessories
Self-tapping Screw A ST3.9X25
Seal (outdoor heat pumps only)
Drain Joint
FERRILE COR FILTER (clip-on)
optionally installed on the communication
cable between the indoor and outdoor unit to
reduce EMI RFI noise.
FLARE NUT ADAPTER
3/8” FFL to ½” flare nut provided with some
indoor models as required to make with the
outdoor units line set.
Dry wall anchors
Number
Q ty/one unit¡
7
Remote controller holder
1
(outdoor heat pumps only)
1 (high wall mount only)
5-8
(depending on models)
5-8
(depending on models)
1
1
Optional
1
(on some models)
1
5
9
11
10
8
3
2
1
Optional
parts
8
9
Note: The seal and drain connector elbow are only available
with some models. Your particular product may not come with
these parts factory supplied, however they can be purchased
locally. All other parts required for installation must be purchased
separately/locally including but not limited to tools, line sets,
insulation etc.