Hearth and Home Technologies ST-550TM-IPI Indoor Fireplace User Manual


 
Heat & Glo • ST-550TM-IPI • 2142-900 Rev. B • 11/08 51
A. Remove Fixed Glass Assembly
See Section 14.F.
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
rebox.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the rebox or underneath in the control cavity.
D. Accessories
Install approved accessories per instructions included
with accessories. Install approved accessories per in-
structions included with accessories. Contact your dealer
for a list of approved accessories.
WARNING! Risk of Fire and Electric Shock! Use ONLY
Hearth & Home Technologies-approved optional acces-
sories with this appliance. Using non-listed accessories
could result in a safety hazard and will void the warranty.
14
14
Appliance Setup
E. Rock Media Placement
WARNING! Risk of Explosion! Follow rock media place-
ment instructions in manual. DO NOT place rock media
directly over burner ports. Improperly placed rock media
will interfere with proper burner operation.
Placing the Rock Media
Rock media is an approved accessory for this appliance.
To place the rock media, follow these instructions.
Figure 14.1 Rock Placement Jig
Figure 14.2 Rock Media on Base Pan
Figure 14.3 Rock Media Jig Removal
Figure 14.4 Burner Slot Free of Rock Media
1. Place the rock placement jig over the burner slot as
shown in Figure 14.1. The rock placement jig is located
in the base of the unit.
2. Place the rock media on the porcelain base pan as
shown in Figure 14.2.
3. Remove the rock placement jig as shown in Figure 14.3.
Place the rock placement jig in the base of the unit when
nished.
4. Make sure that there is no rock media in the burner slot.
See Figure 14.2.