Filter
Top Products
Heat & Glo • SL-550 / 750 / 950TR-E • 2118-900 Rev. L • 11/08 65
Log should touch lava rock retainer
Log should touch lava rock retainer
Figure 7
Figure 7
Log #3: Locate the pin hole on the underside of log #3.
Mate the pin hole with the shoulder screw located on the
burner top. Push the left end of log # 3 toward the back of
the fi rebox until it touches the lava rock retainer.
3
3
Mate shoulder screw with pin hole
Mate shoulder screw with pin hole
3
3
Figure 6
Figure 6
PIN HOLE
PIN HOLE
Figure 8
Figure 8
Bump
Bump
Log #4: Locate the notch at the end of log # 4. Mate the notch
with the tine as shown above. The top end of log #4 should
rest between the end of log #2, and the bump located on log
#1. Swing the knot on log # 4 towards log #3.
4
4
Swing knot towards log #3
Swing knot towards log #3
Mate notch with grate tine
Mate notch with grate tine
Figure 9
Figure 9
Log #5: Locate the notch at the end of log # 5. Mate the
notch with the far right grate tine. The top end of log # 5
should rest on the right side of the “bump” as shown above.
You may need to move log #4 slightly.
5
5
Bump
Bump
Mate notch with grate tine
Mate notch with grate tine
Lava Rock
Lava Rock
Figure 10
Figure 10
Step #6: Apply the supplied lava rock as shown above.
Take care to ensure that no lava rock is placed past the line
indicated in Figure 1.
SL-550TR-E
SL-550TV-E
SL-750TR-E
SL-750TV-E
SL-950TR-E
SL-950TV-E
Log 1 SRV2115-701 SRV2118-701 SRV2121-701
Log 2 SRV2115-702 SRV2118-702 SRV2121-702
Log 3 SRV2115-703 SRV2118-703 SRV2118-703
Log 4 SRV2115-704 SRV2118-704 SRV2121-704
Log 5 SRV2115-705 SRV2118-705 SRV2121-705