Filter
Top Products
Heat & Glo • SL-550 / 750 / 950TR-E • 2118-900 Rev. L • 11/0860
Step 5. Fold bottom fl ap along score line as indicated
in Figure 13.13 and tuck into valve access area of appli-
ance. Splatter guard should fi t securely on front of unit.
Figure 13.13
Once plumbing and wiring are complete on the fi replace,
the lower access panel may be closed until the time that the
splatter guard must be removed for fi ring the appliance.
Figure 13.14
Step 6. To open lower access panel of splatter guard, place
one hand above score line and place two fi ngers from other
hand in the round holes on the front of the splatter guard.
See Figure 13.14. Pull out and fold up the panel as shown
in Figure 13.15. Disengage the tabs on left and right bot-
tom of splatter guard and fi t them into the square holes.
The tabs are now inside the front of the splatter guard;
carefully bend them down. See Figure 13.16.
Figure 13.16
Figure 13.15
To Close the Lower Access Panel:
Carefully disengage the tabs from the square holes and
bend the access panel to its original position. Bend the
center bottom fl ap and insert it into the bottom of the ap-
pliance.
To Remove the Splatter Guard:
Carefully grab splatter guard on or near the vertical center
on the left and right sides. Pull outward gently, but fi rmly,
taking care not to tear or remove the inserted tabs.
Figure 13.18
Figure 13.17