Filter
Top Products
Heat & Glo • SL-550 / 750 / 950TR-E • 2118-900 Rev. L • 11/08 59
C. Splatter Guard
The splatter guard is a piece of corrugated material used to
protect the appliance during the installation process before
fi nishing work on the whole hearth is complete.Splatter
guards may be factory installed or accompany the door of
the unit, depending on the fi replace model. Splatter guards
must be removed before appliance is fi red.
Risk of Fire
• Splatter guard must be removed before lighting
appliance.
• Before splatter guard is installed:
Close ball valve to prevent accidental lighting.
WARNING
To install the Splatter Guard:
Step 2. Crease fl ap on top side of splatter guard using
the scored line as the guide. See Figure 13.9.
Figure 13.9
Step 3. Crease fl aps on left and right sides of splatter guard
using the scored line as the guide. See Figure 13.9.
Step 4. Center the splatter guard in front of the unit as
shown in Figure 13.10. Place the splatter guard in the
unit by guiding the top fl ap into proper position and then
continuing to guide the tabs on the side fl aps into the top
slot on the left and right sides of the appliance. The top
slot is indicated in Figure 13.12. Take care not to bend or
break off the tabs.
Figure 13.11
Figure 13.10
Figure 13.12
TOP SLOT
Step 1. Turn off gas to valve. Red gas shutoff knob is
located on ball valve. Disconnect the 3 volt transformer
from the junction box. See Figure 13.8.
Figure 13.8