Hearth and Home Technologies SL-350TRS-IPI Indoor Fireplace User Manual


 
Heat & Glo • SL-750TRS-IPI-E, SL-550TRS-IPI-E, SL-350TRS-D, SL-350TRS-IPI • 2120-900 Rev. D • 6/07 47
Step 5. Fold bottom ap along score line as indicated
in Figure 11.10 and tuck into valve access area of appli-
ance. Splatter guard should t securely on front of unit.
Figure 11.10
Once plumbing and wiring are complete on the replace,
the lower access panel may be closed until the time that the
splatter guard must be removed for ring the appliance.
Figure 11.11
Step 6. To open lower access panel of splatter guard,
place one hand above score line and place two ngers
from other hand in the round holes on the front of the
splatter guard. See Figure 11.11 Pull out and fold up the
panel as shown in Figure 11.12. Disengage the tabs on
left and right bottom of splatter guard and t them into
the square holes. The tabs are now inside the front of
the splatter guard; carefully bend them down See Figure
11.13.
Figure 11.13
Figure 11.12
To Close the Lower Access Panel:
Carefully disengage the tabs from the square holes and
bend the access panel to its original position. Bend the
center bottom ap and insert it into the bottom of the ap-
pliance.
To Remove the Splatter Guard:
Carefully grab splatter guard on or near the vertical center
on the left and right sides. Pull outward gently, but rmly,
taking care not to tear or remove the inserted tabs.
Figure 11.15
Figure 11.14