Filter
Top Products
6
Heat & Glo • 6000TRSI-AUC • 2078-900 Rev. G • 12/06
Framing should be constructed of
2 X 4 lumber or heavier.
ABC DE
42-1/8 in. 38-19/32 in. 22-1/16 in. 26-7/8 in. 47-3/4 in.
(1070mm) (980mm) (560mm) (684mm) (1060mm)
FIGURE 1.3 Framing Dimensions
B. Framing the Heater
Framing can be built before or after the heater is set in
place. Framing should be positioned to accommodate
wall coverings and heater facing material. The diagram
below shows framing reference dimensions.
The framing
headers may rest
on the heater
standoffs.
CAUTION: MEASURE HEATER DIMENSIONS AND
VERIFY FRAMING METHODS AND WALL COVER-
ING DETAILS, BEFORE FRAMING CONSTRUCTION
BEGINS.
* NOTE: Dimension B taken from finished
hearth frame. Dimensions D and E taken
from bottom of unit.
B*
A
C
86 mm
76 mm
NON-COMBUSTIBLE ZONE
IS DEFINED BY 76MM ABOVE
THE ELBOW FOR THE ENTIRE
WIDTH AND DEPTH (BEHIND
THE FRONT HEADER) OF
THE FIREBOX.
WALL
STUD
E*
D*