Filter
Top Products
27
Heat & Glo • 6000TRSI-AUC • 2078-900 Rev. G • 12/06
C. FAN OPERATION
The accessory fan is wired in series with a speed con-
trol switch and a temperature sensor switch. Set the
speed control to an "ON" position and light the heater.
The temperature sensor switch will automatically start
the fan when the switch warms up—and stop the fan
when it cools down. You can manually stop the fan by
turning the speed control switch to "OFF". See Figure
1.30 for fan wiring diagram.
SWITCH IS SHOWN
IN "ON" POSITION
Figure 2.2
In the event of a power interruption during opera-
tion, either push the OFF button on the remote
control or open access door and push the switch
to OFF (as shown in Figure 39) to shut off
manually. The switch must be returned to the ON
position prior to operation once power is restored.
B. POWER OUTAGE