Filter
Top Products
5100-I WOOD INSERT
Page 16
January 30, 2004
R
250-1960 Rev B
ZERO CLEARANCE ADJUSTABLE TRIM SUPPORT, 2” to 10”
Part No. ADJSPT-12, size 12” x 50”
Included in Kit: (1) Trim Top, (1) Trim Front, (2) Trim Sides, Double-Sided Tape (already installed)
Tools Needed: Phillips Head Screwdriver, Sheet Metal Shears, Measuring Tape, Gloves
1. The 10 screws on each set of scissors will already be
loose when shipped. See Figure 16A.
2. Expand scissors to desired height. Tighten screws
to hold in place using Phillips Head screwdriver. See
Figure 16B.
3. Measure front and side trims to required height to cover
scissors and mark pieces for cutting. Cut excess mate-
rial from top of trim’s edge, not bottom. This edge will be
sharp; wear gloves to prevent injury to your hands. See
Figure 16B.
4. Using sheet metal shears, cut trim along the marked
edge. The cut edge ts under lip of top trim, so it allows
for some variance in your straight edge.
5. The double-sided tape that holds front and side trims
to scissors has a particularly powerful bonding adhe-
sive. Adjustments are extremely difcult once trim has
adhered to tape. Do a dry run rst without removing
paper from tape.
6. Place cut edge of trim under top lip and into position on
scissors. Place side pieces on rst and then front piece.
The front piece overlaps side pieces. NOTE: The trim in
the Flush Mount Kit is one piece.
7. Once you are satised with the positioning, remove trim
and set aside.
8. Remove the paper from double-sided tape that is to
accept trim side. Align side and then press hard against
tape to secure side piece. Repeat for other side. Install
front trim piece last.
NOTE:
3/8” ( 9.5mm) thick tile or like material can be cut to
size and t under lip of top trim edge for a decorative touch.
See Figure 16C.
DOUBLE-SIDED TAPE
DOUBLE-SIDED TAPE
EXPLODED VIEW OF SCISSORS
SCREWS ARE CIRCLED
Figure 16A
Figure 16B
Figure 16C
INSTALL FRONT TRIM LAST.
CORNERS OVERLAP SIDE
TRIM PIECES
EXPAND SCISSORS TO DESIRED
CUT TOP EDGE OF TRIM,
NOT BOTTOM EDGE
Decorative tile may
be installed
Figure 16D