Filter
Top Products
5100-I WOOD INSERT
Page 14
January 30, 2004
R
250-1960 Rev B
BLOWER REPLACEMENT INSTRUCTIONS
Part 832-1991 for Serial Numbers 131586 and below
Part 832-3190 for Serial Numbers 131587 and above
Figure 14A
NOTE: When the speed control is turned clockwise, it will click on to high speed. Continue to turn the speed control
clockwise to decrease the speed. At full clockwise, the blower should blow gently, but should not stop.
1. With the unit plugged in, turn the Speed Control Knob to slow. (Full clockwise.)
2. Use a small screwdriver to adjust the fan speed by turning the adjustment mechanism through the hole on the
side of the Speed Control.
3. Adjust the speed so the fan runs slowly but does not stop. Turn clockwise to slow the fan and counterclockwise
to increase the speed.
FAN SPEED CONTROL ADJUSTMENT, IF NECESSARY*
*The fan Speed Control for this unit is adjusted at the factory, and normally does not require further
adjustment.
Remove 2 Spring Handles
TOOLS NEEDED: #2 PHILLIPS SCREWDRIVER
1) Unplug blower cord from outlet.
2) Pull insert out from the replace.
3) Remove the 2 Air Control spring handles.
4) Remove the lower grill by removing 2 screws in the center of
the grill.
5) Unplug the snap disc by-pass switch and speed control from
the wiring harness for easier access to blower. (Located on
right hand side of stove as you face the unit).
6) Remove screws from blower frame on side of insert.
7) Blower will then slide out through side of insert.
8) Install new blower in same fashion.
9) Re-connect snap disc & speed control to wiring harness and
replace screws in blower frame.
10) Re-install lower grill, replace screws & spring handles.
11) Push insert back into the replace.
12) Plug blower cord back into outlet.
LEFT FAN
AUX POWER
LEFT
RIGHT FAN
POWER IN
SPEED
CONTROL
SNAP DISC
BY-PASS SWITCH
SNAP DISC
Small Red Female
Small Red Female
Small Red Female
Small Red Female
Large Blue Male
Large Blue Male
Lar
g
e Red Female
Large Red Female
Large Red Female
Large Red Female
Large Blue Male
Large Blue Female
Large Blue Female Large Blue Female
Figure 14B
WIRING DIAGRAM