Filter
Top Products
4100-I ACT WOOD INSERT
Page 16
September 1, 2008
R
250-7201E
I(1) Trim Top, (1) Trim Front, (2) Trim Sides, Double-Sided Tape (already installed)
Tools Needed: Phillips Head Screwdriver, Sheet Metal Shears, Measuring Tape, Gloves
1. The 10 screws on each set of scissors will already be loose
when shipped.
2. Expand scissors to desired height. Tighten screws to hold in
place using Phillips Head screwdriver.
. Measure front and side trims to required height to cover scis-
sors and mark pieces for cutting. Cut excess material from
top of trim’s edge, not bottom. This edge will be sharp; wear
gloves to prevent injury to your hands.
4. Using sheet metal shears, cut trim along the marked edge.
The cut edge ts under lip of top trim, so it allows for some
variance in your straight edge.
5. The double-sided tape that holds front and side trims to scis-
sors has a powerful bonding adhesive. Adjustments are
extremely difcult once trim has adhered to tape. Do a dry
run rst without removing paper from tape.
6. Place cut edge of trim under top lip and into position on scis-
sors. Place side pieces on rst and then front piece. The
front piece overlaps side pieces. NOTE: The trim in the Flush
Mount Kit is one piece.
7. Once you are satised with the positioning, remove trim and
set aside.
8. Remove the paper from double-sided tape that is to accept
trim side. Align side and then press hard against tape to
secure side piece. Repeat for other side. Install front trim
piece last.
NOTE:
/8” (9.5mm) thick tile or like material can be cut to size and
t under lip of top trim edge for a decorative touch.
DOUBLE-SIDED TAPE
DOUBLE-SIDED TAPE
SCREWS ARE CIRCLED
EXPLODED VIEW OF SCISSORS
DOOR HANDLE ASSEMBLY
Decorative tile
may be installed
INSTALL FRONT TRIM LAST.
CORNERS OVERLAP SIDE
TRIM PIECES
EXPAND SCISSORS TO DESIRED HEIGHT
CUT TOP EDGE OF TRIM,
NOT BOTTOM EDGE
Adjustment Bolts
Securing
Screw
It is important the door gasket has a proper seal. As the gasket compresses or
“seats” during use, it may become necessary to adjust or tighten the door latch.
1. Loosen securing screw (do not remove).
2. Turn adjustment bolts as need for adjustment (in or out) using 7/16” end
wrench.
. Tighten securing screw to hold adjusted position in place.
Nut 1/4-20
Washer
Door Latch Bracket
Washer, 5/8 x 1/4
Hook Door Latch
Door Handle
Fiber Handle