Filter
Top Products
Page 1
September 1, 2008
4100-I ACT WOOD INSERT
250-7201E
R
SECURING LINER TO CHIMNEY RING
There are two options to secure the liner to the chim-
ney ring:
Option One: If there is enough room on the top of the
insert to work, hand bend the two tabs upward 90°.
Secure the liner with the supplied hex head bolts 1/4-
20-/4.
Option Two: Remove the manifold tubes, berboard
bafe and ceramic blanket. From inside the rebox,
pull liner down through the chimney ring below the
outer skin. There are two pre-drilled holes in the chim-
ney ring 180° apart. Secure the liner with the supplied
hex head bolts 1/4-20-/4.
NOTE:
Tools Needed: Phillips Head Screwdriver
1. Remove three screws and cover plate from back side of insert. Save the screws.
2. Re-attach the cover plate using the same screws to front side of the insert as shown in .
. Repeat same procedure for other side of insert.
OUTSIDE AIR INSTALLATION
2. Re-install plate
1. Remove plate
Attach liner with 2 tabs
2 pre-drilled holes on
chimney ring under outer skin
(access through firebox)
IMPORTANT!
THE ZERO CLEARANCE
FIREPLACE OUTSIDE
AIR MUST BE TURNED
TO “ON”