Filter
Top Products
4100-I ACT WOOD INSERT
Page 14
September 1, 2008
R
250-7201E
PANEL SET and CAST TRIM SET
1. Remove contents from box being careful not to scratch or damage cast trim pieces.
2. Lay the panel set face down on protective covering to prevent scratching the painted surface.
. Secure panel set together with screws provided.
4.
Now bend the tabs down toward the backside of the panel set, on top piece and on each leg. Leave panel set face down.
5. P
lace the corresponding cast trim pieces (2 cast trim legs and 1 cast trim header) underneath panel set, also face down.
6. Place washer provided over tab and secure the trim and panel together with screw. Continue for all tabs.
7. Secure cast footers with screws.
8. Slide assembled panel and trim over top of the insert into place.
9. Secure panels to insert with 8-2 sheet metal screws through tabs on bottom lower inside corners on side panels.
Included in Panel Kit: (2) side panels, left and right; (1) panel top; (2) trim pieces; (1) trim top; (1) fastener package.
Included in Cast Trim Kit: (2) cast trim legs, left and right; (1) cast trim header; (2) cast trim footers, left and right.
Tools Needed: Powered Phillips Head Screw Driver
Panel and Cast Trim must be ordered separately.
1. Screw side panels
to top panel
2. Bend tabs
. Install Cast Trim
Header
2. Bend tabs
Tab with screw hole to
secure panel to insert
Secure side panels to insert with screws
COMPLETED VIEW
STANDARD SIZE: 30-1/2” h x 44-3/4”w
LARGE SIZE:
BASIC STANDARD SIZE: 30”h x 40”w
PANEL and GOLD TRIM SET
1. Repeat Steps 1 - above.
2. To assemble the trim, attach the 2 side trim pieces to the top trim at each corner using the “L” bracket
included in fasteners package.
. Slide panel and trim over top of the insert and into position.
Tab with screw
hole to secure
panel to insert
Screw side
panels to top
panel
View of "L" Bracket
installed