Filter
Top Products
12
Operation
Starting First Fire
Be sure the power cord is plugged into a 120 volt
receptacle. This can be veried by the red power light
on the control panel.
Be sure there is no fuel or other combustibles in
the ash pan prior to lighting.
Fill the hopper with pellets.
Fill the burn pot with pellets to a level just short of
overowing, g. 17.
Adjust feed rate. If this is your rst re or you are trying
different pellets, set the feed adjuster to "4", g. 18.
This is a conservative number and will probably need
to be increased. After you know a feed rate setting that
works well, use that setting. Remember, too high of a
feed rate will waste fuel.
Turn Mode selector to "OFF" and then to "Stove
Temp". This will turn the combustion blower to high.
When starting a re always turn the mode selector to
"OFF" before selecting the desired mode. This resets
the control for start-up.
Turn Temp Dial to 7. This will allow the stove to burn
at maximum for feed rate adjusting purposes.
Apply starting gel to pellets in burn pot and light
the gel. Close the door after lighting. At this point the
distribution and combustion lights will be on and the
feed motor light will be off. As the temperature of the re
increases, the feed motor light will come on and pellets
will feed into the burn pot. As the stove temperature
increases the distribution blower speed will increase.
After 30 to 45 minutes it may be necessary to readjust
the feed rate. The feed rate should be adjusted so
there is about one inch of ash in front of the re, g. 20.
This is a maximum burn position and the stove may not
achieve this position under normal burn rates.
Fig. 17
Fig. 19
Fig. 20
1"
"NEVER USE GASOLINE, GASOLINE-TYPE LANTERN
FUEL, KEROSENE, CHARCOAL LIGHTER FLUID, OR
SIMILAR LIQUIDS TO START OR "FRESHEN UP " A FIRE
IN THIS HEATER. KEEP ALL SUCH LIQUIDS WELL AWAY
FROM THE HEATER WHILE IN USE".
MANUAL START UP
Fig. 18