Filter
Top Products
8
When installing and operating your Harman Advance
Pellet Stove, respect basic safety standards. Read these
instructions carefully before you attempt to install or oper-
ate the Advance. Failure to do so may result in damage to
property or personal injury and may void the product war-
ranty.
Consult with your local building code agency and in-
surance representative before you begin your installation
to ensure compliance with local codes, including the need
for permits and follow-up inspections.
Several issues must be addressed when selecting
a suitable location for your Advance Pellet Stove. Observ-
ing required clearances to combustible materials, the prox-
imity to a safe chimney or venting system, and the acces-
sibility of electrical supply must all be considered. In addi-
tion, selecting a location that takes advantage of the
building's natural air flow is also desirable to maximize
the heating effectiveness of the heater. In many cases,
this is a central location within the building.
Adequate combustion and ventilation air must be pro-
vided.
Place the stove on a noncombustible floor or UL ap-
proved floor protector that extends 6 inches to the front, 6
inches to the sides and 1 inch to the rear of the stove. Fig.
8.
Place the stove away from combustible walls at least
as far as shown in figures 6, and 7.
Note that the clearances shown are minimum for
safety but do not leave much room for access when clean-
ing or servicing. Please take this into account when plac-
ing the stove.
Mobile Home Installation
AFTER THE INSTALLATION IS COMPLETED
Before the first fire is lit, check and record
the high and low draft reading numbers on page
10. Make adjustments to the low draft at this time,
if necessary. See page 10.
Installation
6" 6"
6"
Fig.8
1"
When installing this stove in a mobile home several
requirements must be followed:
1. The unit must be bolted to the floor. This can be
done with 1/4" lag screws throught the 2 holes in
the base plate shown in Fig. 13, Page 9.
2. The unit must also be connected for the outside
air. See page 12.
3. Floor protection and clearances must be followed
as shown above.
4. Unit must be grounded to the metal frame of the
mobile home.
CAUTION: This appliance must be vented to the
outside.
Due to high temperatures, the stove should be placed
out of traffic and away from furniture and draperies.
Children and adults should be alerted to the hazards
of high surface temperatures and should stay away to
avoid burn to skin and/or clothing.
Young children should be carefully supervised when
they are in the same room as the stove.
Clothing and other flammable materials should not
be placed on or near the stove.
FLOOR PROTECTOR
7"
7"
Fig.6
1"
10"
Fig.7
FLOOR PROTECTOR
Installation and repair of this stove should be done by
a qualified service person. The appliance should be in-
spected before use and at least annually by a qualified
service person. More frequent cleaning will be required. It
is imperative that control compartments, burners, and cir-
culating air passageways of the stove be kept clean.
FLOOR
PROTECTOR
Evaluation notes were added to the output document. To get rid of these notes, please order your copy of ePrint IV now.