Filter
Top Products
23
CAUTION
Excessive cleaning force could bend the
small stainless steel ESP Probe, causing
damage.
Fig. 46
Cover Retainer Handle
These surfaces must be even to
close retainer handle.
Combustion
Intake Cover
Right Side Retaining Slot
Fig. 47
Intake Cover Handle
Right Side Tab
Fig.48
ESP Probe
(in rear of flue
tube)
Combustion Fan Blade
Maintenance - Combustion Intake Cover
Cleaning and Maintenance for the
Combustion Intake Cover
You will need to remove the combustion
intake cover to clean the fan blades and rear flue
tube.
Figure 46
Rotate the retainer cover handle counter-clockwise
upward as far as it will go (approximately 90
o
).
Figure 47
Hold the intake cover handle and pull until the side
of the cover at the retainer handle end comes away
from the stove body, approximately 15-20
o
, slide
the right side tab out of the retaining slot.
Figure 48
Clean and inspect the fully exposed combustion
fan blade and flue tube.
Reinstall the combustion intake cover by
first sliding the right side tab into the retainer slot
seen in Figure 47.
Rotate the cover inward until the cover fits
into its hole.
Make sure the two faces (Fig.46) of the
cover and retainer spacer are even and rotate the
retainer handle clockwise until it stops.
Evaluation notes were added to the output document. To get rid of these notes, please order your copy of ePrint IV now.