Filter
Top Products
2. Dress properly. Do not wear loose clothing or jewelry. Contain long hair.
Keep your hair, clothing, and gloves away from moving parts. Loose clothes,
jewelry, or long hair can be caught in moving parts.
3. Avoid accidental starting. Be sure the circuit supplying electrical power is off
before plugging in. Plugging in a Sump Pump with the electrical circuit on invites
accidents.
4. Remove adjusting keys or wrenches before turning the power tool on. A wrench
or a key that is left attached to a moving part of the power tool may result in personal
injury.
5. Do not overreach. Keep proper footing and balance at all times. Proper footing
and balance enables better control of the power tool in unexpected situations.
6. Always wear eye protection. Wear ANSI approved safety impact
goggles and non-skid rubber boots. A hard hat must be used for
appropriate conditions. Wearing work pants and work shirt are
recommended.
TOOL USE AND CARE
1. Do not force the tool. Use the correct tool for your application. The correct tool
will do the job better and safer at the rate for which it is designed.
2. Do not use the power tool if the Automatic Switch (3) does not turn it on or off.
Any tool that cannot be controlled with an Automatic Switch is dangerous and must
be replaced.
3. Disconnect the Power Cord Plug from the power source before making any
adjustments, changing accessories, or storing the tool. Such preventive safety
measures reduce the risk of starting the tool accidentally.
4. Store idle tools out of reach of children and other untrained persons. Tools
are dangerous in the hands of untrained users.
5. Maintain tools with care. Keep tools clean. Properly maintained tools are easier
to control. Do not use a damaged tool. Tag damaged tools “Do not use” until
repaired.
SKU 92274 For technical questions, please call 1-800-444-3353. PAGE 4
6. Check for misalignment or binding of moving parts, breakage of parts, and
any other condition that may affect the tool’s operation. If damaged, have the
tool serviced before using. Many accidents are caused by poorly main tained
tools.