Filter
Top Products
HI200 Hampton Wood Cast Insert 17
DOOR GASKET
If the door gasket requires replacement, 7/8" diameter material must be
used. A proper high temperature gasket adhesive is required. A gasket
repair kit, Part # 846-570 is available from your local Hampton dealer.
GLASS CLEANING
Only clean your glass window when it is cool. Your local retailer can
supply you with special glass cleaner if plain water and a soft cloth does
not remove all deposits.
Remove 4 screws.
GLASS
REPLACEMENT
1) Remove door from unit.
2) To replace the glass remove the 4 screws highlighted in the diagram
below.
3) Lift off the glass retainer and carefully remove the glass.
4) Place new glass in the door, make sure that the glass gasketing will
properly seal your unit.
5) Re-install the glass retainer. Ensure that it rests on the gasket and
not the glass.
6) Secure glass retainer using the 4 screws. Do not wrench down on
the glass as this may cause the glass to break.
7) Place door back on unit.
DOOR REMOVAL
When handling enamel parts, please handle with care as they can
be damaged.
1) Open door fully.
2) Release the push pin at the top of the door and slide out while lifting
up and out from the bottom.
Please be careful when removing the Door and do not drop
onto the Ashlip, it may chip.
Avoid impact on glass doors such
as striking or slamming shut.
MAINTENANCE
Push Pin
DOOR INSTALLATION NOTE
After re-installing the door, carefully
swing open and check the clearance
to the Right Hand Cast Side. If tight or
rubbing, loosen the 7/16 nuts and adjust
the clearance and then re-tighten.