Filter
Top Products
G0637/G0638 Cyclone Dust Collector
-27-
Test Run
When the assembly is complete, test run your
dust collection system to make sure it operates
properly.
If, during the test run, you cannot easily locate
the source of an unusual noise or vibration, stop
using the machine immediately, then review the
Troubleshooting on Page 41.
If you still cannot remedy a problem, contact our
Tech Support at (570) 546-9663 for assistance.
To test run your dust collection system:
1. Make sure you have read the safety instruc-
tions at the beginning of the manual and that
the machine is setup properly.
2. Make sure all tools and objects used during
setup are cleared away from the machine.
3. Review Circuit Requirements on Page
11 and connect the machine to the power
source.
4. Flip the main power switch at the lower left
hand corner of the control box (see
Figure
42).
Note: For the Model G0638, make sure the
EMERGENCY STOP button is popped out by
twisting the knurled knob clockwise.
5. Press the ON/OFF button to turn the machine
ON. Make sure your hand stays poised over
the switch in case you need to quickly turn
the machine
OFF.
6. Listen to and watch for abnormal noises or
actions. The machine should run smoothly
with little or no vibration or rubbing noises.
— If you suspect any problems, immedi
-
ately turn the machine
OFF and discon-
nect the machine from power. Refer to
Troubleshooting on Page 41 to identify
and fix any problems.
—If you cannot solve the problem with the
use of the
Troubleshooting guide, contact
our Tech Support at (570) 546-9663 for
assistance.
7. Press the TIMER button on the control box
and cycle through each of the times to make
sure the indicators light.
8. Press the TIMER button on the remote con-
trol and cycle through the times in the same
manner as Step 7
.
9. Toggle the ON/OFF button on both the con-
trol box and the remote control to make sure
they are working properly.
10. For the G0638 only:
a. Turn the machine OFF.
b. Press the EMERGENCY STOP button
in.
c. Turn the machine ON—nothing should
happen.
d. Turn the machine OFF.
e. Pop the EMERGENCY STOP button out
by twisting the knurled knob clockwise.
f. Pressing the ON/OFF button should now
turn the dust collector
ON.
Figure 42. Control box (Model G0638 shown).
Main Power
Switch
ON/OFF
Button
Timer
Button
EMERGENCY STOP
Button