Filter
Top Products
-18-
G0637/G0638 Cyclone Dust Collector
Assembly
Upper Stand
1. Use (8)
3
⁄8"-16 x
3
⁄4" hex bolts, (16)
3
⁄8" flat
washers, and (8)
3
⁄8"-16 lock nuts to connect
2 upper stand legs, 1 upper stand brace, and
1 lower stand brace —only finger tighten the
fasteners (see Figure 12).
Note: To make the installation of the fasten-
ers easier, use scrap wood to raise the metal
components off the floor.
Figure 12. One side of upper stand assembled.
Upper Stand Brace
Lower Stand Brace
Upper Stand Legs
2. Repeat Step 1 to make the other side of the
upper stand.
Note:
The
5
⁄16" fender washers with a larger
outside diameter will be used to attach the
canister filters in later steps—do not use
them for any other assembly.
Figure 13. Upper stand assembled.
4. Place the level across a corner of the lower
stand braces and move the upper stand
around until that corner is level, then fully
tighten all of the fasteners for that corner (see
Figure 14).
Figure 14. Level positioned on the upper stand.
5. Repeat Step 4 for the rest of the corners,
then set the upper stand assembly aside.
3. Use (16)
3
⁄8"-16 x
3
⁄4" hex bolts, (32)
3
⁄8" flat
washer, and (16)
3
⁄8"-16 lock nuts to con-
nect the two sides of the upper stand with
two upper stand braces and two lower stand
braces—only finger tighten the fasteners
(see Figure 13).