Filter
Top Products
Instructions
10 3A1495C
intake seal on the priming rod as shown in Fig. 20.
26. Install seal retainer (29) over priming rod (34) (Fig.
22).
27. Use an adjustable wrench to tighten seal retainer
securely, then torque to 45 - 55 ft lbs (61 - 75 N.m).
28. Install the priming piston (35 and nut (19) (Fig. 3,
Fig. 4) on priming rod (34) Use an adjustable
wrench to hold the priming rod (34) securely. Use a
second adjustable wrench to tighten nut. Then
torque nut to 70 - 80 in. lbs (7.9 - 9.0 N.m) (Fig. 22
and Fig. 23).
29. Install shovel cylinder (27) over priming rod (34)
(Fig. 24). Use a strap wrench to tighten shovel cylin-
der securely then torque to 45 - 55 ft. lbs (61 - 75
N.m).
Repair Kits
All Repairs:
• Unless otherwise stated, entirely disassemble pump
as described in the pump disassembly instruction
section of this manual.
• Properly discard all replaced parts according to
local and state regulations for disposal of discarded
components.
• Always use all new parts included in the kit to
replace the identical part on the pump.
• Grease all parts prior to reassembly with a thin coat
of lightweight grease.
• Reassemble pump as described in the reassembly
instruction section of this manual.
Fig. 22
Fig. 23
29
19
35
34
34
19, 35
Fig. 24
34
27