Filter
Top Products
Security Pro 1000 23
System Battery Failure
This condition occurs if the emergency backup battery has failed. Status beeps will
start and the SYSTEM STATUS button will light. Press the SYSTEM STATUS but-
ton to hear the trouble message. If your AC power is not working, your security sys-
tem will shut down once the battery has failed. If the condition does not clear after AC
power has been restored and 24 hours have passed, call your security system dealer.
Restoration of Power
This condition occurs after a complete loss of power (AC and battery). When power is
restored, the panel will return to the arming state with the same zones bypassed it had
prior to losing power.
Sensor Failure
This condition occurs if a sensor is not communicating with the panel. Status beeps
will start and the SYSTEM STATUS button will light. Press the SYSTEM STATUS
button to hear which sensor(s) failed. Perform sensor tests. It may be necessary for you
to call your security system dealer if the problem continues.
Sensor Low Battery
This condition occurs if a system sensor has a low battery. The sensor may still be
communicating with the panel. Status beeps will start and the SYSTEM STATUS but-
ton will light. Press the SYSTEM STATUS button to hear which sensor has a low bat-
tery. It may be necessary for you to call your security system dealer to resolve this
problem. Some sensor batteries can be replaced by the homeowner.
Fail-To-Communicate
This condition occurs if your security system cannot communicate to the central mon-
itoring station. Your system will try to report to the central monitoring station 8 times
before it tells you there is a Fail-To-Communicate problem. Status beeps will start and
the System Status button will light. Press the System Status button to hear the trou-
ble message. It may be necessary for you to call your security system dealer if the
problem continues.
Sensor Open
This condition occurs if a door or window is open, a system sensor has been disturbed
and not reset properly. For example, a Door/Window Sensor magnet may have been
removed from the sensor. Your system will indicate this condition to you by causing
the System Status button to light. When you press this button, the system responds
with Sensor # Name open. Correct the problem by resetting the sensor. If this condi-
tion continues, call your security system dealer
Sensor Tampered
This condition occurs when a sensor is physically tampered with. If the system is
armed an alarm will occur. For example, the cover is taken off of one of the sensors.
Your system will indicate this condition to you by causing the System Status button to
light. When you press this button, the system responds with, Sensor # Name tampered.
Correct the problem by resetting the sensor. If this condition continues, call your secu-
rity system dealer.
Option 50 Detected
The panel receiver may be experiencing some interference. The system will call to
notify the central monitoring station about this problem.
Siren 1 or 2 Failure
Call your security system dealer.